Pinouts of Connectors

Two-Wire Modem (25-25) cable pinout

layout
schematic diagram
add this page to bookmarks

This cable should be used for DTE to DCE (for instance computer to modem) connections without hardware handshaking.

25 pin D-SUB FEMALE connector pin-out & layout
25 pin D-SUB FEMALE connector  to the Computer
Female Male Dir
Shield Ground 1 1 
Transmit Data 2 2 -->
Receive Data 3 3 <--
System Ground 7 7 
    
Jumper these:   
Request to Send 4  -->
Clear to Send 5  <--
    
Data Set Ready 6  <--
Carrier Detect 8  <--
Data Terminal Ready 20   -->
    
Request to Send   4 -->
Clear to Send   5 <--
    
Data Set Ready   6 <--
Carrier Detect   8 <--
Data Terminal Ready   20 -->

This information should be correct, but may be not. You can help us to improve this webpage!
You can confirm this document to be correct (be careful), or report an error in document (error may be described in the following webpage). Result of your submission will be used for calculating document status shown at the bottom of this page.
25 pin D-SUB MALE connector pin-outs & layouts
25 pin D-SUB MALE connector  to the Modem
Pinouts.ru > Pinouts of modem cables >  Pinout of Two-Wire Modem (25-25) cable and layout of 25 pin D-SUB FEMALE connector and 25 pin D-SUB MALE connector

Source(s): Hardware Book
Document status: unknown
mark as erroneous!
mark as correct		 0 report(s)
Click one of this links to change document status.
[Discuss at the forum] [Back to index] [Add new pinout]
[Report an error or update]
This information is maintained by pinouts.ru team and provided as a guideline only.
Efforts have been made to ensure it is correct, but it is the responsibility of the user
to verify the data is correct for their application.
45 hits since February 12, 2005