Pinouts of Connectors

8-Inch floppy Disk connector pinout

layout
schematic diagram

add this page to bookmarks

50 pin EDGE or IDC connector at the computer?
Pin Name Dir Description
2 /REDWC <-- Reduced Write Current
4 n/c - Reserved
6 n/c - Reserved
8 n/c - Reserved
10 /FD2S <-- Disk is two sided
12 /DCG <-- Disk has been changed/door open
14 /SIDE --> Side select
16 /DLOCK --> Door lock
18 /HLD --> Head load
20 /INDEX <-- Index Pulse
22 /READY <-- Ready
24 n/c - Not connected
26 /SEL1 <-- Select Drive 1
28 /SEL2 <-- Select Drive 2
30 /SEL3 <-- Select Drive 3
32 /SEL4 <-- Select Drive 4
34 /DIR --> Direction
36 /STEP --> Step
38 /WDAT --> Write data
40 /WGAT --> Write gate
42 /TR00 <-- Track 00 (Zero)
44 /WPROT <-- Write protect
46 /RDATA <-- Read data
48 n/c - Not connected
50 n/c - Not connected

Note: Direction is Computer relative Diskdrive.
Note: All odd pins are GND, Ground.

This information should be correct, but may be not. You can help us to improve this webpage!
You can confirm this document to be correct (be careful), or report an error in document (error may be described in the following webpage). Result of your submission will be used for calculating document status shown at the bottom of this page.
Pinouts.ru > Pinouts of different diskdrives connectors >  Pinout of 8-Inch floppy Disk connector and layout of connector

Source(s): Hardware Book, Dennis Painter
Document status: unknown
mark as erroneous!
mark as correct
0 report(s)
Click one of this links to change document status.
[Discuss at the forum] [Back to index] [Add new pinout]
[Report an error or update]
This information is maintained by pinouts.ru team and provided as a guideline only.
Efforts have been made to ensure it is correct, but it is the responsibility of the user
to verify the data is correct for their application.
83 hits since February 12, 2005