Pinouts of Connectors

ATX Form Factor card pinout

layout
schematic diagram

add this page to bookmarks

The ATX Form Factor Card is used to upgrade AT motherboards to meet ATX standards and support PC97, PC98 specificatioin.

Pin USB 1 USB 2 PS/2 Mouse Infrared
1 +5V DC     " "
2   +5V DC    
3 Data -      
4     Data -  
5 Data +      
6   Data +    
7 Ground      
8   Ground    
9     +5V DC  
10        
11     Mouse Clk  
12     mouse Data  
13       Ground
14     Ground  
15       IR Hi
16       Id in
17       +5V DC
18       IR Out

This information should be correct, but may be not. You can help us to improve this webpage!
You can confirm this document to be correct (be careful), or report an error in document (error may be described in the following webpage). Result of your submission will be used for calculating document status shown at the bottom of this page.
Pinouts.ru > Different motherboard connectors pinouts >  Pinout of ATX Form Factor card and layout of connector

Source(s): comp.sys.cbm General FAQ v3.1 Part 7 from Hardware Book
Document status: unknown
mark as erroneous!
mark as correct
0 report(s)
Click one of this links to change document status.
[Discuss at the forum] [Back to index] [Add new pinout]
[Report an error or update]
This information is maintained by pinouts.ru team and provided as a guideline only.
Efforts have been made to ensure it is correct, but it is the responsibility of the user
to verify the data is correct for their application.
115 hits since February 11, 2005