Pinouts of Connectors

Amiga Video connector pinout

layout
schematic diagram

add this page to bookmarks

23 pin D-SUB MALE connector pin-out & layout
23 pin D-SUB MALE connector  at the amiga
Pin Name Dir Description
1 /XCLK <-- Extern Clock
2 /XCLKEN <-- Extern Clock Enable (47 Ohm)
3 RED --> Analog Red (75 Ohm)
4 GREEN --> Analog Green (75 Ohm)
5 BLUE --> Analog Blue (75 Ohm)
6 DI --> Digital Intensity (47 Ohm)
7 DR --> Digital Red (47 Ohm)
8 DG --> Digital Green (47 Ohm)
9 DB --> Digital Blue (47 Ohm)
10 /CSYNC --> Composite Sync (47 Ohm)
11 /HSYNC --> Horizontal Sync (47 Ohm)
12 /VSYNC --> Vertical Sync (47 Ohm)
13 GNDRTN --- Digital Ground (for /XCLKEN) Don"t connect with pin 16-20.
14 /PIXELSW --> Genlock overlay (47 Ohm)
15 /C1 --> Clock out (47 Ohm)
16 GND --- Video Ground for RED Analog (useful to know because some TVs need specific grounds for specific colors when using SCART/PERITEL SECAM video signal)
17 GND --- Video Ground for GREEN Analog
18 GND --- Video Ground for BLUE Analog
19 GND --- Video Ground for CHV SYNC
20 GND --- Video Ground
21 -12V --> -12 Volts DC (10 mA max) (A500/A600/A1200)
-5V --> -5 Volts DC (10 mA max) (A1000/A2000/A3000/A4000)
22 +12V --> +12 Volts DC (100 mA max)
23 +5V --> +5 Volts DC (100 mA max)

Note: Direction is Computer relative Monitor.

This information should be correct, but may be not. You can help us to improve this webpage!
You can confirm this document to be correct (be careful), or report an error in document (error may be described in the following webpage). Result of your submission will be used for calculating document status shown at the bottom of this page.
Pinouts.ru > Pinouts of video connectors >  Pinout of Amiga Video connector and layout of 23 pin D-SUB MALE connector

Source(s): Commodore 4000 User"s Guide from Commodore, from Hardware Book, updated by Zone
Document status: unknown
mark as erroneous!
mark as correct
0 report(s)
Click one of this links to change document status.
[Discuss at the forum] [Back to index] [Add new pinout]
[Report an error or update]
This information is maintained by pinouts.ru team and provided as a guideline only.
Efforts have been made to ensure it is correct, but it is the responsibility of the user
to verify the data is correct for their application.
66 hits since February 12, 2005