Pinouts of Connectors

C16/+4 Expansion Bus connector pinout

layout
schematic diagram

add this page to bookmarks

Available on Commodore C16, C116 and +4 computers

50 pin FEMALE EDGE (2 mm pitch) connector at the computer
Pin Name Description
1 GND Ground
2 +5V +5 VDC
3 +5V +5 VDC
4 /IRQ Interrupt
5 R/W Read/Write (1=Read, 0=Write)
6 C1HIGH External Cartridge Chip Selects C1 High
7 C2LOW External Cartridge Chip Selects C2 Low (reserved)
8 C2HIGH External Cartridge Chip Selects C2 High (reserved)
9 /CS1 Chip Select Line 1
10 /CS0 Chip Select Line 0
11 /CAS Column Address Strobe
12 MUX DRAM address multiplex control signal
13 BA Bus Available (Low=DMA)
14 D7 Data 7
15 D6 Data 6
16 D5 Data 5
17 D4 Data 4
18 D3 Data 3
19 D2 Data 2
20 D1 Data 1
21 D0 Data 0
22 AEC Address Enable Code
23 EAI External Audio In
24 PHI 2 Artificial Phi 2 signal
25 GND Ground
A GND Ground
B C1LOW External Cartridge Chip Selects C1 Low
C /RESET Reset
D /RAS Row Address Strobe
E PHI 0 Artificial Phi 0 Signal
F A15 Address 15
H A14 Address 14
J A13 Address 13
K A12 Address 12
L A11 Address 11
M A10 Address 10
N A9 Address 9
P A8 Address 8
R A7 Address 7
S A6 Address 6
T A5 Address 5
U A4 Address 4
V A3 Address 3
W A2 Address 2
X A1 Address 1
Y A0 Address 0
Z n/c Not connected
AA n/c Not connected
BB n/c Not connected
CC GND Ground

PHI 2: Address valid on the rising edge, data valid on the falling edge

This information should be correct, but may be not. You can help us to improve this webpage!
You can confirm this document to be correct (be careful), or report an error in document (error may be described in the following webpage). Result of your submission will be used for calculating document status shown at the bottom of this page.
Pinouts.ru > Different motherboard connectors pinouts >  Pinout of C16/+4 Expansion Bus connector and layout of connector

Source(s): Usenet posting in comp.sys.cbm, Pinout specs for cbm machines needed by Lonnie McClure; SAMS Computerfacts CC8 Commodore 16.
Article in C"T September 1986, from Hardware Book
Document status: unknown
mark as erroneous!
mark as correct
0 report(s)
Click one of this links to change document status.
[Discuss at the forum] [Back to index] [Add new pinout]
[Report an error or update]
This information is maintained by pinouts.ru team and provided as a guideline only.
Efforts have been made to ensure it is correct, but it is the responsibility of the user
to verify the data is correct for their application.
38 hits since February 12, 2005