Pinouts of Connectors

C64 Centronics Printer cable pinout

layout
schematic diagram
add this page to bookmarks

Requires a cartridge with Centronics support (TFCIII or ActionReplay.)

UNKNOWN connector  to the C64 UserPort
C64 Dir Printer
GND 1,12,A,N --- 19-30,33 Ground
FLAG2 B <-- 10 Acknowledge
PB0 C --> 2 Data 0
PB1 D --> 3 Data 1
PB2 E --> 4 Data 2
PB3 F --> 5 Data 3
PB4 H --> 6 Data 4
PB5 J --> 7 Data 5
PB6 K --> 8 Data 6
PB7 L --> 9 Data 7
PA2 M --> 1 Strobe
GND 3 --> 31 Initialize Printer

This information should be correct, but may be not. You can help us to improve this webpage!
You can confirm this document to be correct (be careful), or report an error in document (error may be described in the following webpage). Result of your submission will be used for calculating document status shown at the bottom of this page.
36 pin CENTRONICS MALE connector pin-outs & layouts
36 pin CENTRONICS MALE connector  to the Printer
Pinouts.ru > Pinouts and schemes of parallel ports cables >  Pinout of C64 Centronics Printer cable and layout of connector and 36 pin CENTRONICS MALE connector

Source(s): CBM Memorial Page Pinouts, pinout by Roy Kannady, from Hardware Book
Document status: unknown
mark as erroneous!
mark as correct		 0 report(s)
Click one of this links to change document status.
[Discuss at the forum] [Back to index] [Add new pinout]
[Report an error or update]
This information is maintained by pinouts.ru team and provided as a guideline only.
Efforts have been made to ensure it is correct, but it is the responsibility of the user
to verify the data is correct for their application.
58 hits since February 12, 2005