Pinouts of Connectors

C64 RS232 User Port connector pinout

layout
schematic diagram
add this page to bookmarks

Available on the Commodore C64/C128. Software emulated. The signals does not have true RS232 levels. It´s TTL level, and RXD/TXD is inverted. It´s just the normal User Port, used as a RS232 port.

UNKNOWN connector  at the computer
Pin Name RS232 Description
A GND GND Protective Ground
B+C FLAG2+PB0 RxD Receive Data (Must be applied to both pins!)
D PB1 RTS Ready To Send
E PB2 DTR Data Terminal Ready
F PB3 RI Ring Indicator
H PB4 DCD Data Carrier Detect
K PB6 CTS Clear To Send
L PB7 DSR Data Set Ready
M PA2 TxD Transmit Data
N GND GND Signal Ground

This information should be correct, but may be not. You can help us to improve this webpage!
You can confirm this document to be correct (be careful), or report an error in document (error may be described in the following webpage). Result of your submission will be used for calculating document status shown at the bottom of this page.
Pinouts.ru > Pinouts of serial ports >  Pinout of C64 RS232 User Port connector and layout of connector

Source(s): Usenet posting in comp.sys.cbm, Help on modem - c64 by Lasher Glenn, Commodore 64 Programmer´s Reference Guide, from Hardware Book, Arwin Vosselman, Mark Sokos
Document status: unknown
mark as erroneous!
mark as correct		 0 report(s)
Click one of this links to change document status.
[Discuss at the forum] [Back to index] [Add new pinout]
[Report an error or update]
This information is maintained by pinouts.ru team and provided as a guideline only.
Efforts have been made to ensure it is correct, but it is the responsibility of the user
to verify the data is correct for their application.
62 hits since February 12, 2005