Pinouts of Connectors

TG-16 Cartridge connector pinout

layout
schematic diagram

add this page to bookmarks

Available on the TG-16.

UNKNOWN connector  at the TG-16
Pin Name Description
1 ?  
2 ?  
3 A18? Address 18
4 A16 Address 16
5 A15 Address 15
6 A12 Address 12
7 A7 Address 7
8 A6 Address 6
9 A5 Address 5
10 A4 Address 4
11 A3 Address 3
12 A2 Address 2
13 A1 Address 1
14 A0 Address 0
15 D7 Data 7
16 D6 Data 6
17 D5 Data 5
18 GND Ground
19 D4 Data 4
20 D3 Data 3
21 D2 Data 2
22 D1 Data 1
23 D0 Data 0
24 /CE Chip Select
25 A10 Address 10
26 /OE Output Enable
27 A11 Address 11
28 A9 Address 9
29 A8 Address 8
30 A13 Address 13
31 A14 Address 14
32 A17 Address 17
33 A19? Address 19
34 R/W Read/Write
35 ?  
36 ?  
37 ?  
38 +5V +5 VDC

Pin 1 is the short pin on the left (if the card is to inserted forwards)
Pin 38 is the long pin on the right.

This information should be correct, but may be not. You can help us to improve this webpage!
You can confirm this document to be correct (be careful), or report an error in document (error may be described in the following webpage). Result of your submission will be used for calculating document status shown at the bottom of this page.
Pinouts.ru > Pinouts of videogames connectors >  Pinout of TG-16 Cartridge connector and layout of connector

Source(s): Video Games FAQ (Part 3), Pinout by David Shadoff, from Hardware Book
Document status: unknown
mark as erroneous!
mark as correct
0 report(s)
Click one of this links to change document status.
[Discuss at the forum] [Back to index] [Add new pinout]
[Report an error or update]
This information is maintained by pinouts.ru team and provided as a guideline only.
Efforts have been made to ensure it is correct, but it is the responsibility of the user
to verify the data is correct for their application.
42 hits since February 12, 2005