Pinouts of Connectors

Cisco Console Port (at Catalyst 5000 Series Switch) pinout

layout
schematic diagram

add this page to bookmarks

The Cisco Consule Port is used on the Cisco Catalyst 5000 Series Switch Supervisor Engine III

8 pin RJ45 FEMALE connector pin-out & layout
8 pin RJ45 FEMALE connector  at the Cisco routers
Console Port Console device
Pin +Signal Connect to
1 looped to 8  
2 (DTR) DSR
3 (RxD) TxD
4 (GND) GND
5 (GND) GND
6 (TxD) RxD
7 (DSR) DTR
8 looped to 1  

This information should be correct, but may be not. You can help us to improve this webpage!
You can confirm this document to be correct (be careful), or report an error in document (error may be described in the following webpage). Result of your submission will be used for calculating document status shown at the bottom of this page.
8 pin RJ45 MALE connector pin-outs & layouts
8 pin RJ45 MALE connector  at the cable
Pinouts.ru > Pinouts of serial ports >  Pinout of Cisco Console Port (at Catalyst 5000 Series Switch) and layout of 8 pin RJ45 FEMALE connector and 8 pin RJ45 MALE connector

Source(s): comp.sys.cbm General FAQ v3.1 Part 7, from Hardware Book
Document status: unknown
mark as erroneous!
mark as correct
0 report(s)
Click one of this links to change document status.
[Discuss at the forum] [Back to index] [Add new pinout]
[Report an error or update]
This information is maintained by pinouts.ru team and provided as a guideline only.
Efforts have been made to ensure it is correct, but it is the responsibility of the user
to verify the data is correct for their application.
60 hits since February 12, 2005