Pinouts of Connectors

Mitsumi CD-ROM connector pinout

layout
schematic diagram

add this page to bookmarks

40 pin IDC MALE connector pin-out & layout
40 pin IDC MALE connector  at the controller & CD-ROM
Pin Name Description
1 A0 Address Bit 0
2 GND Ground
3 A1 Address Bit 1
4 GND Ground
5 n/c Not connected
6 GND Ground
7 n/c Not connected
8 GND Ground
9 n/c Not connected
10 GND Ground
11 n/c Not connected
12 GND Ground
13 INT Interrupt
14 GND Ground
15 REQ Data request For DMA
16 GND Ground
17 ACK Data Acknowledge For DMA
18 GND Ground
19 RE Read Enable
20 GND Ground
21 WE Write Enable
22 GND Ground
23 EN Bus Enable
24 GND Ground
25 DB0 Data Bit 0
26 GND Ground
27 DB1 Data Bit 1
28 GND Ground
29 DB2 Data Bit 2
30 GND Ground
31 DB3 Data Bit 3
32 GND Ground
33 DB4 Data Bit 4
34 GND Ground
35 DB5 Data Bit 5
36 GND Ground
37 DB6 Data Bit 6
38 GND Ground
39 DB7 Data Bit 7
40 GND Ground

This information should be correct, but may be not. You can help us to improve this webpage!
You can confirm this document to be correct (be careful), or report an error in document (error may be described in the following webpage). Result of your submission will be used for calculating document status shown at the bottom of this page.
40 pin IDC FEMALE connector pin-outs & layouts
40 pin IDC FEMALE connector  at the cable
Pinouts.ru > Pinouts of different diskdrives connectors >  Pinout of Mitsumi CD-ROM connector and layout of 40 pin IDC MALE connector and 40 pin IDC FEMALE connector

Source(s): SoundFX 16-bit Multimedia Kit Hardware Manual from Reveal; Keith Solomon
Document status: unknown
mark as erroneous!
mark as correct
0 report(s)
Click one of this links to change document status.
[Discuss at the forum] [Back to index] [Add new pinout]
[Report an error or update]
This information is maintained by pinouts.ru team and provided as a guideline only.
Efforts have been made to ensure it is correct, but it is the responsibility of the user
to verify the data is correct for their application.
62 hits since February 12, 2005