Pinouts of Connectors

CDTV Video Slot connector pinout

layout
schematic diagram
add this page to bookmarks

Used for RF-modulator usually.

 2  4  6  8 10 12 14 16 18 20 22 24 26 28 30
-- -- -- -- -- -- -- -- -- -- -- -- -- -- --
-- -- -- -- -- -- -- -- -- -- -- -- -- -- --
 1  3  5  7  9 11 13 15 17 19 21 24 25 27 29
Pin Name Description
1 GND Video Ground
2 GND Video Ground
3 XCLK External Genlock Clock (in)
4 R Red (in to video card)
5 /XCLKEN Enables External Clock on XCLK.
6 BR Buffered Red (out from video card)
7 GND Video Ground
8 G Green (in to video card)
9 GMS0 Genlock mode 0 (from computer, genlock button)
10 BG Buffered Green (out from video card)
11 GMS1 Genlock mode 1 (from computer, genlock button)
12 B Blue (in to video card)
13 /PIXELSW Genlock signal
14 BB Buffered Blue (out from video card)
15 VSYNC Vertical Sync (in to video card)
16 CSYNC Horizontal Sync (in to video card)
17 HSYNC Composite Sync (in to video card)
18 BCSYNC Buffered Composite Sync (out from video card)
19 GND Video Ground
20 AUDR Audio Right Output (from computer to RF modulator)
21 DGND Digital Ground
22 AUDL Audio Left Output (from computer to RF modulator)
23 -12V -12 VDC (can be -5 VDC instead)
24 DGND Digital Ground
25 +12V +12 VDC
26 /CD/TV CD/TV button. (Low=CDTV video on RF, High=Antenna)
27 VCC +5 VDC
28 /CCK 3.58 MHz color clock (C1 clock)
29 GND Video Ground
30 VCC +5 VDC

This information should be correct, but may be not. You can help us to improve this webpage!
You can confirm this document to be correct (be careful), or report an error in document (error may be described in the following webpage). Result of your submission will be used for calculating document status shown at the bottom of this page.
Pinouts.ru > Pinouts of video connectors >  Pinout of CDTV Video Slot connector and layout of connector

Source(s): Darren Ewaniuk"s CDTV Technical Information, from Hardware Book
Document status: unknown
mark as erroneous!
mark as correct		 0 report(s)
Click one of this links to change document status.
[Discuss at the forum] [Back to index] [Add new pinout]
[Report an error or update]
This information is maintained by pinouts.ru team and provided as a guideline only.
Efforts have been made to ensure it is correct, but it is the responsibility of the user
to verify the data is correct for their application.
50 hits since February 11, 2005