Pinouts of Connectors

Centronics to LapLink Adapter pinout

layout
schematic diagram

add this page to bookmarks

This adapter will allow you to use a normal printercable Centronics) as a LapLink/InterLink cable

36 pin CENTRONICS FEMALE connector pin-out & layout
36 pin CENTRONICS FEMALE connector  to the cable
Name 36-Cen 25-DSub Name
Data Bit 0 2 15 Error
Data Bit 1 3 13 Select
Data Bit 2 4 12 Paper Out
Data Bit 3 5 10 Acknowledge
Data Bit 4 6 11 Busy
Acknowledge 10 5 Data Bit 3
Busy 11 6 Data Bit 4
Paper Out 12 4 Data Bit 2
Select 13 3 Data Bit 1
Error 32 2 Data Bit 0
Reset 16 16 Reset
Select 17 17 Select
Signal Ground 19-30+33 18-25 Signal Ground

This information should be correct, but may be not. You can help us to improve this webpage!
You can confirm this document to be correct (be careful), or report an error in document (error may be described in the following webpage). Result of your submission will be used for calculating document status shown at the bottom of this page.
25 pin D-SUB MALE connector pin-outs & layouts
25 pin D-SUB MALE connector  to the computer
Pinouts.ru > Pinouts and schemes of parallel ports cables >  Pinout of Centronics to LapLink Adapter and layout of 36 pin CENTRONICS FEMALE connector and 25 pin D-SUB MALE connector

Source(s): Hardware Book, Petr Krc
Document status: unknown
mark as erroneous!
mark as correct
0 report(s)
Click one of this links to change document status.
[Discuss at the forum] [Back to index] [Add new pinout]
[Report an error or update]
This information is maintained by pinouts.ru team and provided as a guideline only.
Efforts have been made to ensure it is correct, but it is the responsibility of the user
to verify the data is correct for their application.
56 hits since February 12, 2005