Pinouts of Connectors

Conrad Electronics MM3610D connector pinout

layout
schematic diagram

add this page to bookmarks

This connector is available on the Conrad Electronics Multimeter 3610D and is used to connect it to a computer.

5 pin conrad special connector  at the multimeter
Conrad Name Description Dir
1 RTS Request To Send <--
2 RXD Receive Data -->
3 TXD Transmit Data <--
4 DTR Data Terminal Ready <--
5 GND Ground ---

Note: Since the multimeter is a DCE the pin naming can seem strange.

This information should be correct, but may be not. You can help us to improve this webpage!
You can confirm this document to be correct (be careful), or report an error in document (error may be described in the following webpage). Result of your submission will be used for calculating document status shown at the bottom of this page.
Pinouts.ru > Pinouts of different devices connectors >  Pinout of Conrad Electronics MM3610D connector and layout of 5 pin conrad special connector

Source(s): Hardware Book, Anselm Belz
Document status: unknown
mark as erroneous!
mark as correct
0 report(s)
Click one of this links to change document status.
[Discuss at the forum] [Back to index] [Add new pinout]
[Report an error or update]
This information is maintained by pinouts.ru team and provided as a guideline only.
Efforts have been made to ensure it is correct, but it is the responsibility of the user
to verify the data is correct for their application.
42 hits since February 12, 2005