Pinouts of Connectors

C64 Control Port connector pinout

layout
schematic diagram

add this page to bookmarks

9 pin D-SUB MALE connector pin-out & layout
9 pin D-SUB MALE connector  at the computer

Control Port 1

Pin Name Dir Comment
1 JOYA0 <--  
2 JOYA1 <--  
3 JOYA2 <--  
4 JOYA4 <--  
5 POT AY <->  
6 BUTTON A/LP <->  
7 +5V --> 50 mA max
8 GND ---  
9 POT AX <->  

Control Port 2

Pin Name Dir Comment
1 JOYB0 <--  
2 JOYB1 <--  
3 JOYB2 <--  
4 JOYB4 <--  
5 POT BY <->  
6 BUTTON B <->  
7 +5V --> 50 mA max
8 GND ---  
9 POT BX <->  

Note: Direction is Computer relative Device.
Note: Pot is a linear 470 kOhm (±10 %)

This information should be correct, but may be not. You can help us to improve this webpage!
You can confirm this document to be correct (be careful), or report an error in document (error may be described in the following webpage). Result of your submission will be used for calculating document status shown at the bottom of this page.
9 pin D-SUB FEMALE connector pin-outs & layouts
9 pin D-SUB FEMALE connector  at the joystick cable
Pinouts.ru > Pinouts of input devices (keyboards, mices, joysticks) >  Pinout of C64 Control Port connector and layout of 9 pin D-SUB MALE connector and 9 pin D-SUB FEMALE connector

Source(s): Amiga 4000 User´s Guide from Commodore, Commodore 64 Programmer´s Reference Guide, from Hardware Book, Arwin Vosselman, Amiga 4000 User´s Guide from Commodore, Commodore 64 Programmer´s Reference Guide
Document status: unknown
mark as erroneous!
mark as correct
0 report(s)
Click one of this links to change document status.
[Discuss at the forum] [Back to index] [Add new pinout]
[Report an error or update]
This information is maintained by pinouts.ru team and provided as a guideline only.
Efforts have been made to ensure it is correct, but it is the responsibility of the user
to verify the data is correct for their application.
61 hits since February 12, 2005