Pinouts of Connectors

DEC DLV11-J Serial connector pinout

layout
schematic diagram

add this page to bookmarks

Available on the DEC DLV11-J Serial card

10 pin IDC male connector pin-out & layout
10 pin IDC male connector  at the Serial card (is numbering correct??)
Pin Name Dir Description
1 CLK ? Clock
2 GND --- Ground
3 TXD+ --> Transmit data +
4 TXD- --> Transmit data - (0V for RS-232, Reader enable for 20mA)
5 GND --- Ground
6 n/c - Not connected (no pin)
7 RXD- <-- Receive data -
8 RXD+ <-- Receive data +
9 GND --- Ground
10 +12V --> +12 VDC

Note: Direction is Serial card relative other Devices.

This information should be correct, but may be not. You can help us to improve this webpage!
You can confirm this document to be correct (be careful), or report an error in document (error may be described in the following webpage). Result of your submission will be used for calculating document status shown at the bottom of this page.
Pinouts.ru > Pinouts of serial ports >  Pinout of DEC DLV11-J Serial connector and layout of 10 pin IDC male connector

Source(s): DEC DLV11-J Printset, M8043-0-1, sheet 7 and Ben Harris
Document status: unknown
mark as erroneous!
mark as correct
0 report(s)
Click one of this links to change document status.
[Discuss at the forum] [Back to index] [Add new pinout]
[Report an error or update]
This information is maintained by pinouts.ru team and provided as a guideline only.
Efforts have been made to ensure it is correct, but it is the responsibility of the user
to verify the data is correct for their application.
52 hits since February 12, 2005