Pinouts of Connectors

ESDI cable pinout

layout
schematic diagram

add this page to bookmarks

The ESDI interface requires two cables, one for control and one for data. The control cable is shared between the two drives.

34 pin IDC FEMALE connector pin-out & layout
34 pin IDC FEMALE connector  to the controller

Each drive has each own data cable. By twisting some wires on the control cable it won"t be necessary to set the ID for each drive, since the twist will do the job. Wires 25 to 29 should be twisted between drive 1 & drive 2.

Controller           Drive 2   Twist   Drive 1

+--+                   +--+            +--+

|::|===================|  |============|  |  <-Pin 1

|::|===================|  |============|  |

|::|===================|  |============|  |

|::|===================|  |============|  |

|::|===================|  |=====\/=====|  |

|::|===================|  |=====/\=====|  |

|::|===================|  |============|  |

+--+                   +--+            +--+
Controller Drive 1 Drive 2
Wire 1-24 1-9 1-9 1-9
Wire 25 25 29 25
Wire 26 26 28 26
Wire 27 27 27 27
Wire 28 28 26 28
Wire 29 29 25 29
Wire 30-34 30-34 30-34 30-34

Data cable

20 PIN IDC FEMALE (To the Controller)
20 PIN IDC FEMALE (To the Drive)

20 PIN IDC FEMALE to the Controller.
20 PIN IDC FEMALE to the Drive.

Controller Drive
Wire 1-20 1-20 1-20

This information should be correct, but may be not. You can help us to improve this webpage!
You can confirm this document to be correct (be careful), or report an error in document (error may be described in the following webpage). Result of your submission will be used for calculating document status shown at the bottom of this page.
34 pin IDC FEMALE connector pin-outs & layouts
34 pin IDC FEMALE connector  to the diskdrive 1 or 2
Pinouts.ru > Pinouts of cables for disk drives >  Pinout of ESDI cable and layout of 34 pin IDC FEMALE connector and 34 pin IDC FEMALE connector

Source(s): TheRef TechTalk and Hardware Book, TheRef TechTalk
Document status: unknown
mark as erroneous!
mark as correct
0 report(s)
Click one of this links to change document status.
[Discuss at the forum] [Back to index] [Add new pinout]
[Report an error or update]
This information is maintained by pinouts.ru team and provided as a guideline only.
Efforts have been made to ensure it is correct, but it is the responsibility of the user
to verify the data is correct for their application.
57 hits since February 12, 2005