pinouts

Ethernet 100Base-T4 Crossover cable

pinout (распиновка)

запомнить адрес в закладки

This cable can be used to connect two computers together without a hub, or to connect two hubs together (without using an uplink port). If you´re connecting two hubs together and one of them has an uplink port, use a straight cable.

разъем 8 pin RJ45 MALE
8 pin RJ45 MALE connector  to the network interface card 1
Name Pin Pin Name
TX_D1+ 1 3 RX_D2+
TX_D1- 2 6 RX_D2-
RX_D2+ 3 1 TX_D1+
RX_D2- 6 2 TX_D1-
BI_D3+ 4 7 BI_D4+
BI_D3- 5 8 BI_D4-
BI_D4+ 7 4 BI_D3+
BI_D4- 8 5 BI_D3-
There are 2 types of cross-cables:

Note 1: It´s important that each pair is kept as a pair. TX+ & TX- must be in the pair, and RX+ & RX- must together in another pair etc. (Just as the table above shows).

8 pin RJ45 MALE
8 pin RJ45 MALE connector  to the network interface card 2
Pinouts.ru > Кабели для локальных сетей >  Распиновка Ethernet 100Base-T4 Crossover cable использующего разъем 8 pin RJ45 MALE и разъем 8 pin RJ45 MALE

Источник(и): Hardware Book, Kim Scholte
Статус документа: подтвержденный
отметить как ошибочный!
отметить как правильный
2 отзыв(ов)
Щелкните по одной из ссылок для изменения статуса документа.
[Обсудить на форуме] [Назад к оглавлению] [Добавить распайку]
[Сообщить об ошибке или обновлении]
Maintained by pinouts.ru team
This information is provided as a guideline only.
Efforts have been made to ensure it is correct, but it is the responsibility of the user
to verify the data is correct for their application
131 hits since February 11, 2005