Pinouts of Connectors

Ethernet 100Base-T4 connector pinout

layout
schematic diagram
add this page to bookmarks

100Base-T4 uses all four pairs. 100Base-TX only uses two pairs

8 pin RJ45 FEMALE connector pin-out & layout
8 pin RJ45 FEMALE connector  at the network interface cards/hubs
Pin Name Description
1 TX_D1+ Tranceive Data+
2 TX_D1- Tranceive Data-
3 RX_D2+ Receive Data+
4 BI_D3+ Bi-directional Data+
5 BI_D3- Bi-directional Data-
6 RX_D2- Receive Data-
7 BI_D4+ Bi-directional Data+
8 BI_D4- Bi-directional Data-

Note: TX & RX are swapped on Hub´s. Don´t know about Bi-directional data

This information should be correct, but may be not. You can help us to improve this webpage!
You can confirm this document to be correct (be careful), or report an error in document (error may be described in the following webpage). Result of your submission will be used for calculating document status shown at the bottom of this page.
8 pin RJ45 MALE connector pin-outs & layouts
8 pin RJ45 MALE connector  at the cables
Pinouts.ru > Pinouts of local network connectors >  Pinout of Ethernet 100Base-T4 connector and layout of 8 pin RJ45 FEMALE connector and 8 pin RJ45 MALE connector

Source(s): Hardware Book, Kim Scholte
Document status: unknown
mark as erroneous!
mark as correct		 0 report(s)
Click one of this links to change document status.
[Discuss at the forum] [Back to index] [Add new pinout]
[Report an error or update]
This information is maintained by pinouts.ru team and provided as a guideline only.
Efforts have been made to ensure it is correct, but it is the responsibility of the user
to verify the data is correct for their application.
121 hits since February 11, 2005