Pinouts of Connectors

C128 Expansion Bus connector pinout

layout
schematic diagram

add this page to bookmarks

Available at the Commodore 128

44 pin FEMALE EDGE connector at the computer
Pin Name Description
1 GND System Ground
2 +5V System Vcc
3 +5V System Vcc
4 /IRQ Interrupt request
5 R/W System Read/Write Signal
6 DClock 8.18MHz Video Dot Clock
7 I/O1 I/O Chip select $de00-deff
8 /GAME Sensed for memory map configuration
9 /EXROM Sensed for memory map configuration
10 I/O2 I/O Chip select $df00-dfff
11 /ROML External ROM select $8000-Bfff
12 BA Bus available output
13 /DMA Direct memory access input
14 D7 Data bit 7
15 D6 Data bit 6
16 D5 Data bit 5
17 D4 Data bit 4
18 D3 Data bit 3
19 D2 Data bit 2
20 D1 Data bit 1
21 D0 Data bit 0
22 GND System Ground
A GND System Ground
B /ROMH External ROM Select $c000-ffff
C /RESET System Reset Signal
D /NMI Non-Maskable Interrupt
E 1MHz System 1MHz clock
F TA15 Translated address bit 15
H TA14 Translated address bit 14
J TA13 Translated address bit 13
K TA12 Translated address bit 12
L TA11 Translated address bit 11
M TA10 Translated address bit 10
N TA9 Translated address bit 9
P TA8 Translated address bit 8
R SA7 Shared address bit 7
S SA6 Shared address bit 6
T SA5 Shared address bit 5
U SA4 Shared address bit 4
V SA3 Shared address bit 3
W SA2 Shared address bit 2
X SA1 Shared address bit 1
Y SA0 Shared address bit 0
Z GND System Ground

This information should be correct, but may be not. You can help us to improve this webpage!
You can confirm this document to be correct (be careful), or report an error in document (error may be described in the following webpage). Result of your submission will be used for calculating document status shown at the bottom of this page.
Pinouts.ru > Different motherboard connectors pinouts >  Pinout of C128 Expansion Bus connector and layout of connector

Source(s): Commodore 128 Programmers reference guide.
Document status: unknown
mark as erroneous!
mark as correct
0 report(s)
Click one of this links to change document status.
[Discuss at the forum] [Back to index] [Add new pinout]
[Report an error or update]
This information is maintained by pinouts.ru team and provided as a guideline only.
Efforts have been made to ensure it is correct, but it is the responsibility of the user
to verify the data is correct for their application.
47 hits since February 12, 2005