Pinouts of Connectors

Amiga External Diskdrive connector pinout

layout
schematic diagram

add this page to bookmarks

23 pin D-SUB FEMALE connector pin-out & layout
23 pin D-SUB FEMALE connector  at the Amiga
Pin Name Dir Description
1 /RDY <-> Disk Ready
2 /DKRD <-- Disk Read Data
3 GND --- Ground
4 GND --- Ground
5 GND --- Ground
6 GND --- Ground
7 GND --- Ground
8 /MTRXD OC Disk Motor Control
9 /SEL2 OC Select Drive 2
10 /DRES OC Disk Reset
11 /CHNG <-> Disk Removed From Drive-Latched Low
12 +5V --> +5 Volts DC (250 mA max)
13 /SIDE --> Select Disk Side (0=Upper, 1=Lower)
14 /WPRO <-> Disk is Write Protected
15 /TKO <-> Drive Head position over Track 0
16 /DKWE OC Disk Write Enable
17 /DKWD OC Disk Write Data
18 /STEP OC Step the Head-Pulse, First low, then high
19 DIR OC Select Head Direction (0=Inner, 1=Outer)
20 /SEL3 OC Select Drive 3
21 /SEL1 OC Select Drive 1
22 /INDEX OC Disk Index Pulse
23 +12V --> +12 Volts DC (160 mA max, 540 mA surge

Note: Direction is Computer relative Diskdrive

This information should be correct, but may be not. You can help us to improve this webpage!
You can confirm this document to be correct (be careful), or report an error in document (error may be described in the following webpage). Result of your submission will be used for calculating document status shown at the bottom of this page.
Pinouts.ru > Pinouts of different diskdrives connectors >  Pinout of Amiga External Diskdrive connector and layout of 23 pin D-SUB FEMALE connector

Source(s): Amiga 4000 User"s Guide from Commodore, from Hardware Book
Document status: unknown
mark as erroneous!
mark as correct
0 report(s)
Click one of this links to change document status.
[Discuss at the forum] [Back to index] [Add new pinout]
[Report an error or update]
This information is maintained by pinouts.ru team and provided as a guideline only.
Efforts have been made to ensure it is correct, but it is the responsibility of the user
to verify the data is correct for their application.
43 hits since February 12, 2005