Pinouts of Connectors

Floppy cable pinout

layout
schematic diagram

add this page to bookmarks

34 pin IDC FEMALE connector pin-out & layout
34 pin IDC FEMALE connector  to the Controller

The original floppy cable required that each drive was jumpered to the right ID. But IBM come up with an idea to avoid jumpering the floppies.
If wire 10-16 are twisted before the last connector the jumpering is avoided. Each drive should be jumpered to act as Drive 2. If only one drive is used then leave the middle connector free.
The IDC could also be an edge connector on some old drives.

Controller           Drive 2   Twist   Drive 1
+--+                   +--+            +--+
|::|===================|  |============|  |  <-Pin 1
|::|===================|  |=====\/=====|  |
|::|===================|  |=====/\=====|  |
|::|===================|  |============|  |
|::|===================|  |============|  |
|::|===================|  |============|  |
|::|===================|  |============|  |
+--+                   +--+            +--+
Controller Drive 1 Drive 2
Wire 1-9 1-9 1-9 1-9
Wire 10 10 16 10
Wire 11 11 15 11
Wire 12 12 14 12
Wire 13 13 13 13
Wire 14 14 12 14
Wire 15 15 11 15
Wire 16 16 10 16
Wire 17-34 17-34 17-34 17-34

This information should be correct, but may be not. You can help us to improve this webpage!
You can confirm this document to be correct (be careful), or report an error in document (error may be described in the following webpage). Result of your submission will be used for calculating document status shown at the bottom of this page.
34 pin IDC FEMALE connector pin-outs & layouts
34 pin IDC FEMALE connector  to the Drive 2 & Drive 1
Pinouts.ru > Pinouts of cables for disk drives >  Pinout of Floppy cable and layout of 34 pin IDC FEMALE connector and 34 pin IDC FEMALE connector

Source(s): TheRef TechTalk, from Hardware Book
Document status: unknown
mark as erroneous!
mark as correct
0 report(s)
Click one of this links to change document status.
[Discuss at the forum] [Back to index] [Add new pinout]
[Report an error or update]
This information is maintained by pinouts.ru team and provided as a guideline only.
Efforts have been made to ensure it is correct, but it is the responsibility of the user
to verify the data is correct for their application.
94 hits since February 12, 2005