pinouts

IDE cable

pinout (распиновка)

запомнить адрес в закладки

разъем 40 pin IDC FEMALE
40 pin IDC FEMALE connector  to the Controller

The IDE interface requires only one cable. All pins straight from 1 to 1, 2 to 2 and so on. The drives can be connected in any order. Only remember that one should be jumpered as Master and the other as Slave. If only one drive is used, jumper it as Single (if such a mode exists, or most common Master else).

Controller         Drive 1 or 2   Drive 1 or 2
+--+                   +--+            +--+
|::|===================|::|============|::|  <-Pin 1
|::|===================|::|============|::|
|::|===================|::|============|::|
|::|===================|::|============|::|
|::|===================|::|============|::|
|::|===================|::|============|::|
|::|===================|::|============|::|
+--+                   +--+            +--+
Controller Drive 1 Drive 2
Wire 1-40 1-40 1-40 1-40

40 pin IDC FEMALE
40 pin IDC FEMALE connector  to the Drive 1 & Drive 2
Pinouts.ru > Кабели для дисководов >  Распиновка IDE cable использующего разъем 40 pin IDC FEMALE и разъем 40 pin IDC FEMALE

Источник(и): Hardware Book
Статус документа: подтвержденный
отметить как ошибочный!
отметить как правильный
1 отзыв(ов)
Щелкните по одной из ссылок для изменения статуса документа.
[Обсудить на форуме] [Назад к оглавлению] [Добавить распайку]
[Сообщить об ошибке или обновлении]
Maintained by pinouts.ru team
This information is provided as a guideline only.
Efforts have been made to ensure it is correct, but it is the responsibility of the user
to verify the data is correct for their application
103 hits since February 12, 2005