Pinouts of Connectors

IDE cable pinout

layout
schematic diagram

add this page to bookmarks

40 pin IDC FEMALE connector pin-out & layout
40 pin IDC FEMALE connector  to the Controller

The IDE interface requires only one cable. All pins straight from 1 to 1, 2 to 2 and so on. The drives can be connected in any order. Only remember that one should be jumpered as Master and the other as Slave. If only one drive is used, jumper it as Single (if such a mode exists, or most common Master else).

Controller         Drive 1 or 2   Drive 1 or 2
+--+                   +--+            +--+
|::|===================|::|============|::|  <-Pin 1
|::|===================|::|============|::|
|::|===================|::|============|::|
|::|===================|::|============|::|
|::|===================|::|============|::|
|::|===================|::|============|::|
|::|===================|::|============|::|
+--+                   +--+            +--+
Controller Drive 1 Drive 2
Wire 1-40 1-40 1-40 1-40

40 pin IDC FEMALE connector pin-outs & layouts
40 pin IDC FEMALE connector  to the Drive 1 & Drive 2
Pinouts.ru > Pinouts of cables for disk drives >  Pinout of IDE cable and layout of 40 pin IDC FEMALE connector and 40 pin IDC FEMALE connector

Source(s): Hardware Book
Document status: correct
mark as erroneous!
mark as correct
1 report(s)
Click one of this links to change document status.
[Discuss at the forum] [Back to index] [Add new pinout]
[Report an error or update]
This information is maintained by pinouts.ru team and provided as a guideline only.
Efforts have been made to ensure it is correct, but it is the responsibility of the user
to verify the data is correct for their application.
147 hits since February 11, 2005