Pinouts of Connectors

C16/C116/+4 Joystick connector pinout

layout
schematic diagram
add this page to bookmarks

9 pin D-SUB MALE connector pin-out & layout
9 pin D-SUB MALE connector  at the Atari
Pin Name Dir Comment
1 JOYA0 <--  
2 JOYA1 <--  
3 JOYA2 <--  
4 JOYA3 <--  
5 +5VDC -->  
6 BUTTON A ?  
7 GND ---  
8 COMMON A ? ? Is connected to DATA2 thru a buffer.

Joystick 2

Pin Name Dir Comment
1 JOYB0 <--  
2 JOYB1 <--  
3 JOYB2 <--  
4 JOYB3 <--  
5 +5VDC -->  
6 BUTTON B ?  
7 GND ---  
8 COMMON B ? ? Is connected to DATA1 thru a buffer.

Note: Direction is Computer relative Joystick.
Note: Connect Direction and Button(L/R) to Ground for action. And Both Button to Button L and Button R for action.

This information should be correct, but may be not. You can help us to improve this webpage!
You can confirm this document to be correct (be careful), or report an error in document (error may be described in the following webpage). Result of your submission will be used for calculating document status shown at the bottom of this page.
9 pin D-SUB FEMALE connector pin-outs & layouts
9 pin D-SUB FEMALE connector  at the joystick cable
Pinouts.ru > Pinouts of input devices (keyboards, mices, joysticks) >  Pinout of C16/C116/+4 Joystick connector and layout of 9 pin D-SUB MALE connector and 9 pin D-SUB FEMALE connector

Source(s): SAMS Computerfacts CC8 Commodore 16., from Hardware Book, Arwin Vosselman
Document status: unknown
mark as erroneous!
mark as correct		 0 report(s)
Click one of this links to change document status.
[Discuss at the forum] [Back to index] [Add new pinout]
[Report an error or update]
This information is maintained by pinouts.ru team and provided as a guideline only.
Efforts have been made to ensure it is correct, but it is the responsibility of the user
to verify the data is correct for their application.
36 hits since February 12, 2005