Pinouts of Connectors

Apple Macintosh Serial connector pinout

layout
schematic diagram

add this page to bookmarks

This connector is present on Macintosh 128K, 512K, and 512K enhanced.

9 pin D-SUB FEMALE connector pin-out & layout
9 pin D-SUB FEMALE connector  at the computer
Pin Name Dir Description
1 GND --- Ground
2 +5V --> +5 VDC. Don"t use this one, it may be converted into output handshake in later equipment.
3 GND --- Ground
4 Tx+ --> Transmit Data, positive going component
5 Tx- --> Transmit Data, negative going component
6 +12V --> +12 VDC
7 DSR/HSK <-- Handshake input. Signal name depends on mode: Used for Flow Control or Clock In.
8 Rx+ <-- Receive Data, positive going component
9 Rx- <-- Receive Data, negative going component
a. When connecting to an RS-232 device, use HSKi with data set ready (DSR) or other handshaking signals, depending on the device to be connected.
b.When connecting to an RS-232 device, connect pin 8 to pin 3 (ground).

Note: Direction is Computer relative Equipment.

This information should be correct, but may be not. You can help us to improve this webpage!
You can confirm this document to be correct (be careful), or report an error in document (error may be described in the following webpage). Result of your submission will be used for calculating document status shown at the bottom of this page.
9 pin D-SUB MALE connector pin-outs & layouts
9 pin D-SUB MALE connector  at the mouse cable
Pinouts.ru > Pinouts of serial ports >  Pinout of Apple Macintosh Serial connector and layout of 9 pin D-SUB FEMALE connector and 9 pin D-SUB MALE connector

Source(s): Apple Tech Info Library, Article ID: TECHINFO-0001424; Ben Harris
Document status: unknown
mark as erroneous!
mark as correct
0 report(s)
Click one of this links to change document status.
[Discuss at the forum] [Back to index] [Add new pinout]
[Report an error or update]
This information is maintained by pinouts.ru team and provided as a guideline only.
Efforts have been made to ensure it is correct, but it is the responsibility of the user
to verify the data is correct for their application.
53 hits since February 11, 2005