Pinouts of Connectors

NeoGeo Joystick connector pinout

layout
schematic diagram
add this page to bookmarks

Available on the NeoGeo videogame.

14 pin CANNON (2 rows) ?? connector at the computer
Pin Name Dir Description
1 GND --- Ground
2 n/c - Not connected
3 SELECT <-- Select Button
4 BUTTOND <-- "D" Button
5 BUTTONB <-- "B" Button
6 RIGHT <-- Right
7 DOWN <-- Down
8 n/c - Not connected
9 BUTTOND <-- "D" Button, again?
10 n/c - Not connected
11 START <-- Start Button
12 BUTTONC <-- "C" Button
13 BUTTONA <-- "A" Button
14 LEFT <-- Left
15 UP <-- Up

Note: Direction is Computer relative Joystick.

This information should be correct, but may be not. You can help us to improve this webpage!
You can confirm this document to be correct (be careful), or report an error in document (error may be described in the following webpage). Result of your submission will be used for calculating document status shown at the bottom of this page.
Pinouts.ru > Pinouts of videogames connectors >  Pinout of NeoGeo Joystick connector and layout of connector

Source(s): Hardware Book, Enzo
Document status: unknown
mark as erroneous!
mark as correct		 0 report(s)
Click one of this links to change document status.
[Discuss at the forum] [Back to index] [Add new pinout]
[Report an error or update]
This information is maintained by pinouts.ru team and provided as a guideline only.
Efforts have been made to ensure it is correct, but it is the responsibility of the user
to verify the data is correct for their application.
47 hits since February 12, 2005