Pinouts of Connectors

Novell and Procomp External SCSI connector pinout

layout
schematic diagram

add this page to bookmarks

This interface is nowadays considered obsolete.

37 pin D-SUB FEMALE connector pin-out & layout
37 pin D-SUB FEMALE connector  at the controller
Pin Name Dir Description
1 GND --- Ground
2 GND --- Ground
3 GND --- Ground
4 GND --- Ground
5 GND --- Ground
6 GND --- Ground
7 GND --- Ground
8 GND --- Ground
9 GND --- Ground
10 GND --- Ground
11 GND --- Ground
12 GND --- Ground
13 GND --- Ground
14 GND --- Ground
15 GND --- Ground
16 GND --- Ground
17 GND --- Ground
18 GND --- Ground
19 TERMPWR <-> Termination Power
20 /DB0 <-> Data Bus 0
21 /DB1 <-> Data Bus 1
22 /DB2 <-> Data Bus 2
23 /DB3 <-> Data Bus 3
24 /DB4 <-> Data Bus 4
25 /DB5 <-> Data Bus 5
26 /DB6 <-> Data Bus 6
27 /DB7 <-> Data Bus 7
28 /DBP <-> Data Bus Parity
29 /ATN <-- Attention
30 /BSY <-> Busy
31 /ACK <-- Acknowledge
32 /RST <-> Reset
33 /MSG --> Message
34 /SEL <-> Select
35 /C/D --> Control/Data
36 /REQ --> Request
37 /I/O --> Input/Output

Note: Direction is Device relative Bus (other Devices).

This information should be correct, but may be not. You can help us to improve this webpage!
You can confirm this document to be correct (be careful), or report an error in document (error may be described in the following webpage). Result of your submission will be used for calculating document status shown at the bottom of this page.
Pinouts.ru > Pinouts of different harddrives connectors >  Pinout of Novell and Procomp External SCSI connector and layout of 37 pin D-SUB FEMALE connector

Source(s): Black Box Corporation, FaxBack document for SCSI, from Hardware Book, Randy Hoffman
Document status: unknown
mark as erroneous!
mark as correct
0 report(s)
Click one of this links to change document status.
[Discuss at the forum] [Back to index] [Add new pinout]
[Report an error or update]
This information is maintained by pinouts.ru team and provided as a guideline only.
Efforts have been made to ensure it is correct, but it is the responsibility of the user
to verify the data is correct for their application.
52 hits since February 12, 2005