Pinouts of Connectors

Parallel (Olivetti M10) connector pinout

layout
schematic diagram
add this page to bookmarks

Available on an old portable computer called Olivetti M10

26 pin IDC MALE connector pin-out & layout
26 pin IDC MALE connector  at the computer
Pin Name Dir Description
1 /STROBE --> Strobe
2 D0 --> Data Bit 0
3 D1 --> Data Bit 1
4 D2 --> Data Bit 2
5 D3 --> Data Bit 3
6 D4 --> Data Bit 4
7 D5 --> Data Bit 5
8 D6 --> Data Bit 6
9 D7 --> Data Bit 7
10 /ACK <-- Acknowledge
11 BUSY <-- Busy
12 PE <-- Paper End
13 SELIN <-- Select In
14 GND --- Signal Ground
15 GND --- Signal Ground
16 GND --- Signal Ground
17 GND --- Signal Ground
18 GND --- Signal Ground
19 GND --- Signal Ground
20 GND --- Signal Ground
21 GND --- Signal Ground
22 GND --- Signal Ground
23 GND --- Signal Ground
24 GND --- Signal Ground
25 RESETGND --- Reset Ground
26 /RESET <-- Reset

Note: Direction is Computer relative Device.

This information should be correct, but may be not. You can help us to improve this webpage!
You can confirm this document to be correct (be careful), or report an error in document (error may be described in the following webpage). Result of your submission will be used for calculating document status shown at the bottom of this page.
Pinouts.ru > Pinouts and schemes of parallel ports connectors >  Pinout of Parallel (Olivetti M10) connector and layout of 26 pin IDC MALE connector

Source(s): Hardware Book, Filippo Fiani
Document status: unknown
mark as erroneous!
mark as correct		 0 report(s)
Click one of this links to change document status.
[Discuss at the forum] [Back to index] [Add new pinout]
[Report an error or update]
This information is maintained by pinouts.ru team and provided as a guideline only.
Efforts have been made to ensure it is correct, but it is the responsibility of the user
to verify the data is correct for their application.
37 hits since February 12, 2005