Paravision SX1 to IDE cable pinout |
layout |
Can be used to connect a normal IDE harddisk to the Paravision SX1. Paravision was earlier known as Microbotics
37 pin D-SUB FEMALE connector to the controller |
Note: Pin 18+19 (+5V) can be used to power the harddisk. But most harddisks require both +5V and +12V.
| 40 pin IDC FEMALE connector to the hard disk | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Pinouts.ru > Pinouts of cables for disk drives > Pinout of Paravision SX1 to IDE cable and layout of 37 pin D-SUB FEMALE connector and 40 pin IDC FEMALE connector Source(s): Hardware Book | unknown | |
mark as correct |
0 report(s) | |
Click one of this links to change document status. |