Pinouts of Connectors

Paravision SX-1 External IDE connector pinout

layout
schematic diagram

add this page to bookmarks

Paravision was formerly Microbotics.

37 pin D-SUB FEMALE connector pin-out & layout
37 pin D-SUB FEMALE connector  at the controller
Pin Name Description
1 /IDE-RESET Drive Reset
2 D0 Data bit 0
3 D2 Data bit 2
4 D4 Data bit 4
5 D6 Data bit 6
6 GND Ground
7 D8 Data bit 8
8 D10 Data bit 10
9 D12 Data bit 12
10 D14 Data bit 14
11 GND Ground
12 GND Ground
13 GND Ground
14 GND Ground
15 GND Ground
16 GND Ground
17 GND Ground
18 +5V 5V Power
19 +5V 5V Power
20 GND Ground
21 D1 Data bit 1
22 D3 Data bit 3
23 D5 Data bit 5
24 D7 Data bit 7
25 GND Ground
26 D9 Data bit 9
27 D11 Data bit 11
28 D13 Data bit 13
29 D15 Data bit 15
30 /IOW I/O Write
31 /IOR I/O Read
32 IDE-IRQ Interrupt Request
33 IDE-A2 Address bit 2
34 IDE-A1 Address bit 1
35 IDE-A0 Address bit 0
36 /BICS1 Chip Select 1
37 /BICS0 Chip Select 0

This information should be correct, but may be not. You can help us to improve this webpage!
You can confirm this document to be correct (be careful), or report an error in document (error may be described in the following webpage). Result of your submission will be used for calculating document status shown at the bottom of this page.
Pinouts.ru > Pinouts of different harddrives connectors >  Pinout of Paravision SX-1 External IDE connector and layout of 37 pin D-SUB FEMALE connector

Source(s): SX-1 External IDE connector, usenet posting by Mike Pinso at Paravision, from Hardware Book
Document status: unknown
mark as erroneous!
mark as correct
0 report(s)
Click one of this links to change document status.
[Discuss at the forum] [Back to index] [Add new pinout]
[Report an error or update]
This information is maintained by pinouts.ru team and provided as a guideline only.
Efforts have been made to ensure it is correct, but it is the responsibility of the user
to verify the data is correct for their application.
73 hits since February 11, 2005