Pinouts of Connectors

SCSI cable (D-Sub to Hi D-Sub) pinout

layout
schematic diagram
add this page to bookmarks

25 pin D-SUB MALE connector pin-out & layout
25 pin D-SUB MALE connector  to the Amiga/Mac
DSub Hi DSub
Request 1 49
Message 2 46
Input/Output 3 50
Reset 4 45
Acknowledge 5 44
Busy 6 43
Data Bus 0 8 26
Data Bus 3 10 29
Data Bus 5 11 31
Data Bus 6 12 32
Data Bus 7 13 33
Control/Data 15 48
Attention 17 41
Select 19 47
Data Parity 20 34
Data Bus 1 21 27
Data Bus 2 22 28
Data Bus 4 23 30
Termination Power 25 38

Note: All the other pins (7+9+14+16+18+24) at the DSub should be connected to pins 1-25 at the Hi-density D-Sub connector

This information should be correct, but may be not. You can help us to improve this webpage!
You can confirm this document to be correct (be careful), or report an error in document (error may be described in the following webpage). Result of your submission will be used for calculating document status shown at the bottom of this page.
50 pin HI-DENSITY D-SUB MALE connector pin-outs & layouts
50 pin HI-DENSITY D-SUB MALE connector  to the peripheral
Pinouts.ru > Pinouts of cables for disk drives >  Pinout of SCSI cable (D-Sub to Hi D-Sub) and layout of 25 pin D-SUB MALE connector and 50 pin HI-DENSITY D-SUB MALE connector

Source(s): Hardware Book
Document status: unknown
mark as erroneous!
mark as correct		 0 report(s)
Click one of this links to change document status.
[Discuss at the forum] [Back to index] [Add new pinout]
[Report an error or update]
This information is maintained by pinouts.ru team and provided as a guideline only.
Efforts have been made to ensure it is correct, but it is the responsibility of the user
to verify the data is correct for their application.
66 hits since February 12, 2005