Pinouts of Connectors

SCSI-II External Hi D-Sub (Single-ended) connector pinout

layout
schematic diagram

add this page to bookmarks

50 pin HI-DENSITY D-SUB FEMALE connector pin-out & layout
50 pin HI-DENSITY D-SUB FEMALE connector  at the controller & devices
Pin Name Dir Description
1-25 GND --- Ground
26 DB0 <-> Data Bus 0
27 DB1 <-> Data Bus 1
28 DB2 <-> Data Bus 2
29 DB3 <-> Data Bus 3
30 DB4 <-> Data Bus 4
31 DB5 <-> Data Bus 5
32 DB6 <-> Data Bus 6
33 DB7 <-> Data Bus 7
34 PARITY <-> Data Parity (odd Parity)
35 GND --- Ground
36 GND --- Ground
37 GND --- Ground
38 TMPWR <-> Termination Power
39 GND --- Ground
40 GND --- Ground
41 /ATN <-- Attention
42 n/c - Not connected
43 /BSY <-> Busy
44 /ACK <-- Acknowledge
45 /RST <-> Reset
46 /MSG --> Message
47 /SEL <-> Select
48 /C/D --> Control/Data
49 /REQ --> Request
50 /I/O --> Input/Output

Note: Direction is Device relative Bus (other Devices)

This information should be correct, but may be not. You can help us to improve this webpage!
You can confirm this document to be correct (be careful), or report an error in document (error may be described in the following webpage). Result of your submission will be used for calculating document status shown at the bottom of this page.
50 pin HI-DENSITY D-SUB MALE connector pin-outs & layouts
50 pin HI-DENSITY D-SUB MALE connector  at the cable
Pinouts.ru > Pinouts of different harddrives connectors >  Pinout of SCSI-II External Hi D-Sub (Single-ended) connector and layout of 50 pin HI-DENSITY D-SUB FEMALE connector and 50 pin HI-DENSITY D-SUB MALE connector

Source(s): Hardware Book
Document status: unknown
mark as erroneous!
mark as correct
0 report(s)
Click one of this links to change document status.
[Discuss at the forum] [Back to index] [Add new pinout]
[Report an error or update]
This information is maintained by pinouts.ru team and provided as a guideline only.
Efforts have been made to ensure it is correct, but it is the responsibility of the user
to verify the data is correct for their application.
57 hits since February 12, 2005