Pinouts of Connectors

SCSI External D-Sub (Future Domain) connector pinout

layout
schematic diagram

add this page to bookmarks

Seems to be available on some Future Domain SCSI-controllers only.

25 pin D-SUB FEMALE connector pin-out & layout
25 pin D-SUB FEMALE connector  at the controller
Pin Name Dir Description
1 GND --- Ground
2 DB1 <-> Data Bus 1
3 DB3 <-> Data Bus 3
4 DB5 <-> Data Bus 5
5 DB7 <-> Data Bus 7
6 GND --- Ground
7 /SEL <-> Select
8 GND --- Ground
9 TMPWR <-> Termination Power
10 /RST <-> Reset
11 C/D --> Control/Data
12 I/O --> Input/Output
13 GND --- Ground
14 DB0 <-> Data Bus 0
15 DB2 <-> Data Bus 2
16 DB4 <-> Data Bus 4
17 DB6 <-> Data Bus 6
18 PARITY <-> Data Parity
19 GND --- Ground
20 /ATN <-- Attention
21 /MSG --> Message
22 /ACK <-- Acknowledge
23 BSY <-> Busy
24 /REQ --> Request
25 GND --- Ground

Note: Direction is Device relative Bus (other Devices)

This information should be correct, but may be not. You can help us to improve this webpage!
You can confirm this document to be correct (be careful), or report an error in document (error may be described in the following webpage). Result of your submission will be used for calculating document status shown at the bottom of this page.
25 pin D-SUB MALE connector pin-outs & layouts
25 pin D-SUB MALE connector  at the cable
Pinouts.ru > Pinouts of different harddrives connectors >  Pinout of SCSI External D-Sub (Future Domain) connector and layout of 25 pin D-SUB FEMALE connector and 25 pin D-SUB MALE connector

Source(s): TheRef TechTalk, from Hardware Book
Document status: unknown
mark as erroneous!
mark as correct
0 report(s)
Click one of this links to change document status.
[Discuss at the forum] [Back to index] [Add new pinout]
[Report an error or update]
This information is maintained by pinouts.ru team and provided as a guideline only.
Efforts have been made to ensure it is correct, but it is the responsibility of the user
to verify the data is correct for their application.
48 hits since February 12, 2005