Pinouts of Connectors

Serial (Amiga 1000) connector pinout

layout
schematic diagram
add this page to bookmarks

25 pin D-SUB MALE connector pin-out & layout
25 pin D-SUB MALE connector  at the Amiga 1000
Pin Name Dir Description
1 SHIELD --- Shield Ground
2 TXD --> Transmit Data
3 RXD <-- Receive Data
4 RTS --> Request to Send
5 CTS <-- Clear to Send
6 DSR <-- Data Set Ready
7 GND --- System Ground
8 CD <-- Carrier Detect
9 n/c -  
10 n/c -  
11 n/c -  
12 n/c -  
13 n/c -  
14 -5V --> -5 Volts DC (50mA max)
15 AUDO --> Amiga Audio Out (Left)
16 AUDI <-- Amiga Audio In (Right)
17 EB - EB=Buffered Port Clock 716 kHz
18 /INT2 ? Interrupt 2
19 n/c -  
20 DTR --> Data Terminal Ready
21 +5V --> +5 Volts DC
22 n/c -  
23 +12V --> +12 Volts DC (20 mA max)
24 /C2 --> C2=Clock 3.58MHz
25 /RESET --> Reset

Note: Direction is DTE (Computer) relative DCE (Modem).
Note: Do not connect SHIELD(1) to GND(7)

This information should be correct, but may be not. You can help us to improve this webpage!
You can confirm this document to be correct (be careful), or report an error in document (error may be described in the following webpage). Result of your submission will be used for calculating document status shown at the bottom of this page.
Pinouts.ru > Pinouts of serial ports >  Pinout of Serial (Amiga 1000) connector and layout of 25 pin D-SUB MALE connector

Source(s): Amiga 4000 User"s Guide from Commodore, from Hardware Book
Document status: unknown
mark as erroneous!
mark as correct		 0 report(s)
Click one of this links to change document status.
[Discuss at the forum] [Back to index] [Add new pinout]
[Report an error or update]
This information is maintained by pinouts.ru team and provided as a guideline only.
Efforts have been made to ensure it is correct, but it is the responsibility of the user
to verify the data is correct for their application.
39 hits since February 12, 2005