Pinouts of Connectors

Serial (Amiga) connector pinout

layout
schematic diagram
add this page to bookmarks

25 pin D-SUB MALE connector pin-out & layout
25 pin D-SUB MALE connector  at the computer
Pin Name Dir Description
1 SHIELD --- Shield Ground
2 TXD --> Transmit Data
3 RXD <-- Receive Data
4 RTS --> Request to Send
5 CTS <-- Clear to Send
6 DSR <-- Data Set Ready
7 GND --- System Ground
8 CD <-- Carrier Detect
9 +12V --> +12 Volts DC (20 mA max)
10 -12V --> -12 Volts DC (20 mA max)
11 AUDO --> Amiga Audio Out (Left)
12 n/c - Speed Indicate
13 n/c -  
14 n/c -  
15 n/c -  
16 n/c -  
17 n/c -  
18 AUDI <-- Amiga Audio In (Right)
19 n/c -  
20 DTR --> Data Terminal Ready
21 n/c -  
22 RI <-- Ring Indicator
23 n/c -  
24 n/c -  
25 n/c -  

Note: Direction is DTE (Computer) relative DCE (Modem).
Note: Do not connect SHIELD(1) to GND(7).

This information should be correct, but may be not. You can help us to improve this webpage!
You can confirm this document to be correct (be careful), or report an error in document (error may be described in the following webpage). Result of your submission will be used for calculating document status shown at the bottom of this page.
25 pin D-SUB FEMALE connector pin-outs & layouts
25 pin D-SUB FEMALE connector  at the cable
Pinouts.ru > Pinouts of serial ports >  Pinout of Serial (Amiga) connector and layout of 25 pin D-SUB MALE connector and 25 pin D-SUB FEMALE connector

Source(s): Amiga 4000 User"s Guide from Commodore, from Hardware Book
Document status: unknown
mark as erroneous!
mark as correct		 0 report(s)
Click one of this links to change document status.
[Discuss at the forum] [Back to index] [Add new pinout]
[Report an error or update]
This information is maintained by pinouts.ru team and provided as a guideline only.
Efforts have been made to ensure it is correct, but it is the responsibility of the user
to verify the data is correct for their application.
48 hits since February 12, 2005