Pinouts of Connectors

Serial (MSX) connector pinout

layout
schematic diagram
add this page to bookmarks

9 pin D-SUB FEMALE connector pin-out & layout
9 pin D-SUB FEMALE connector  at the computer
Pin Name Dir Description
1 PG - Protective Ground
2 TXD --> Transmit Data
3 RXD <-- Receive Data
4 RTS --> Request to Send
5 CTS <-- Clear to Send
6 DSR <-- Data Set Ready
7 GND - Signal Ground
8 DCD <-- Carrier Detect
9 DTR --> Data Terminal Ready

Note: Direction is DTE (Computer) relative DCE (Modem)

This information should be correct, but may be not. You can help us to improve this webpage!
You can confirm this document to be correct (be careful), or report an error in document (error may be described in the following webpage). Result of your submission will be used for calculating document status shown at the bottom of this page.
Pinouts.ru > Pinouts of serial ports >  Pinout of Serial (MSX) connector and layout of 9 pin D-SUB FEMALE connector

Source(s): Mayer´s SV738 X´press I/O map, from Hardware Book
Document status: unknown
mark as erroneous!
mark as correct		 0 report(s)
Click one of this links to change document status.
[Discuss at the forum] [Back to index] [Add new pinout]
[Report an error or update]
This information is maintained by pinouts.ru team and provided as a guideline only.
Efforts have been made to ensure it is correct, but it is the responsibility of the user
to verify the data is correct for their application.
44 hits since February 11, 2005