Pinouts of Connectors

APC Back-UPS cable (PN 940-0020B) pinout

layout
schematic diagram

add this page to bookmarks

9 pin D-SUB MALE connector pin-out & layout
9 pin D-SUB MALE connector  to the UPS
DB-9 Male
(UPS end)
DB-9 Female
(PC end)
Signal Name
N/C 1  N/A
N/C 2  N/A
N/C 3  N/A
1 4  Data Terminal Ready
4,9 5  Signal Ground*
N/C 6  N/A
N/C 7  N/A
2 8  Clear To Send
N/C  N/A

* There are two different configuration, one in which both 4 and 9 on the male end are connected to 5 on the female end, and one in which only 4 on the male end is connected to 5 on the male end.

This information should be correct, but may be not. You can help us to improve this webpage!
You can confirm this document to be correct (be careful), or report an error in document (error may be described in the following webpage). Result of your submission will be used for calculating document status shown at the bottom of this page.
9 pin D-SUB FEMALE connector pin-outs & layouts
9 pin D-SUB FEMALE connector  to the computer
Pinouts.ru > Pinouts and schemes of devices cables and adapters >  Pinout of APC Back-UPS cable (PN 940-0020B) and layout of 9 pin D-SUB MALE connector and 9 pin D-SUB FEMALE connector

Document status: unknown
mark as erroneous!
mark as correct
0 report(s)
Click one of this links to change document status.
[Discuss at the forum] [Back to index] [Add new pinout]
[Report an error or update]
This information is maintained by pinouts.ru team and provided as a guideline only.
Efforts have been made to ensure it is correct, but it is the responsibility of the user
to verify the data is correct for their application.
181 hits since February 11, 2005