Pinouts of Connectors

Apple video/composite out pinout

layout
schematic diagram

add this page to bookmarks

The iMac G5 detects the type of display adapter that is plugged in and programs the graphics IC to route the appropriate video signals to the connector. The signal assignments on the video connector when the composite adapter is attached are shown

14 pin Apple video connector pin-out & layout
14 pin Apple video connector
Composite video and S-video signals can be displayed on either an NTSC display or a PAL display. When a display is connected by way of the composite adapter, the computer detects this configuration and enables the composite and S-video outputs.
Pin Signal Description
1Ground  
2n.c.  
3n.c.  
4Ground  
5S-video C  
6Ground  
7S-video Y  
8+5 volts  
9Composite video  
10DDC data  
11DDC clock  
12Ground  
13Ground (for /Cable Detect)  
14Ground  

This information should be correct, but may be not. You can help us to improve this webpage!
You can confirm this document to be correct (be careful), or report an error in document (error may be described in the following webpage). Result of your submission will be used for calculating document status shown at the bottom of this page.
Pinouts.ru > Pinouts of video connectors >  Pinout of Apple video/composite out and layout of 14 pin Apple video connector

Source(s): iMac G5 developer note
Document status: unknown
mark as erroneous!
mark as correct
0 report(s)
Click one of this links to change document status.
[Discuss at the forum] [Back to index] [Add new pinout]
[Report an error or update]
This information is maintained by pinouts.ru team and provided as a guideline only.
Efforts have been made to ensure it is correct, but it is the responsibility of the user
to verify the data is correct for their application.
62 hits since February 12, 2005