Pinouts of Connectors

Apple SCSI connector pinout

layout
schematic diagram

add this page to bookmarks

This connector is present on the Macintosh PowerBook series (except the Duo 210/230).

30 pin Apple HDI-30 connector pin-out & layout
30 pin Apple HDI-30 connector  at the Apple computer, looking into cable-side connector
Pin Name Description
1 SCSI-Mode SCSI disk mode enable signal
2 Data0 Data bit 0
3 GND Signal ground
4 Data1 Data bit 1
5 Termpwr +5 volts termination power
6 Data2 Data bit 2
7 Data3 Data bit 3
8 GND Signal ground
9 ACK Acknowledge
10 GND Signal ground
11 Data4 Data bit 4
12 GND Signal ground
13 GND Signal ground
14 Data5 Data bit 5
15 GND Signal ground
16 Data6 Data bit 6
17 GND Signal ground
18 Data7 Data bit 7
19 PARITY Data parity
20 GND Signal ground
21 REQ Request
22 GND Signal ground
23 BUSY Busy
24 GND Signal ground
25 ATN Attention
26 C/D Control/data
27 RST Reset
28 MSG Message
29 SEL Select
30 I/O Input/output

This information should be correct, but may be not. You can help us to improve this webpage!
You can confirm this document to be correct (be careful), or report an error in document (error may be described in the following webpage). Result of your submission will be used for calculating document status shown at the bottom of this page.
Pinouts.ru > Pinouts of different harddrives connectors >  Pinout of Apple SCSI connector and layout of 30 pin Apple HDI-30 connector

Source(s): Apple "Ports and Pinouts"
Document status: unknown
mark as erroneous!
mark as correct
0 report(s)
Click one of this links to change document status.
[Discuss at the forum] [Back to index] [Add new pinout]
[Report an error or update]
This information is maintained by pinouts.ru team and provided as a guideline only.
Efforts have been made to ensure it is correct, but it is the responsibility of the user
to verify the data is correct for their application.
49 hits since February 12, 2005