Pinouts of Connectors

Bosh 5xx-7xx mobile phones connector pinout

layout
schematic diagram

add this page to bookmarks

full pinout

16 pin mobile 2 rows w/antenna left mobile special connector pin-out & layout
16 pin mobile 2 rows w/antenna left mobile special connector  at the mobile phone (keypad up)
PinNameSignal DescriptionDirection
8 VINInput voltage - supply pinIN
16 C-BUSBi-directional serial control busIN/OUT
7 I-BUSData input (internal 100k pullup)IN
15 PA_BIAS_ONTrigger signal synchronous withr TX burst
6 V-BATTConnected directly to the MS battery
14 HF_ENABLEHF enable output
5 IGNITIONSensing ignition (in car kit)
13 D-BUSData outputOUT
4 CHG-IDCharger ID - detects type of charger
12 GNDGround-this pin is checked by HF
3 A-ULAnalog input to phone
11 AGNDAnalog ground
2 A-DLAnalog output from phone
10 AGNDAnalog ground
1 EQUIP-IDPulled low by HF, internal pullup 100k
9 GNDGround

This information should be correct, but may be not. You can help us to improve this webpage!
You can confirm this document to be correct (be careful), or report an error in document (error may be described in the following webpage). Result of your submission will be used for calculating document status shown at the bottom of this page.
Pinouts.ru > Pinouts of cellular phones connectors >  Pinout of Bosh 5xx-7xx mobile phones connector and layout of 16 pin mobile 2 rows w/antenna left mobile special connector

Document status: unknown
mark as erroneous!
mark as correct
0 report(s)
Click one of this links to change document status.
[Discuss at the forum] [Back to index] [Add new pinout]
[Report an error or update]
This information is maintained by pinouts.ru team and provided as a guideline only.
Efforts have been made to ensure it is correct, but it is the responsibility of the user
to verify the data is correct for their application.
81 hits since February 11, 2005