Pinouts of Connectors

Cassette TI-99/4a connector pinout

layout
schematic diagram
add this page to bookmarks

9 pin D-SUB MALE connector pin-out & layout
9 pin D-SUB MALE connector  at the computer
Pin Name Dir Coment
1 Cass 1 motor control OUT CRU bit 22
2 Dito OUT neg
3 Output to tape 2 OUT CRU bit 25
4 Audio gate OUT CRU bit 24
5 Output to tape 2 OUT neg
6 Cass 2 motor control OUT CRU bit 23
7 Dito OUT neg
8 Input from tape 1 or 2 IN CRU bit 27
9 Dito IN neg

Note: Direction is Computer relative Cassette.
Note: Cassette 1 can´t be written to.

This information should be correct, but may be not. You can help us to improve this webpage!
You can confirm this document to be correct (be careful), or report an error in document (error may be described in the following webpage). Result of your submission will be used for calculating document status shown at the bottom of this page.
9 pin D-SUB FEMALE connector pin-outs & layouts
9 pin D-SUB FEMALE connector  at the Cassette cable
Pinouts.ru > Pinouts of different diskdrives connectors >  Pinout of Cassette TI-99/4a connector and layout of 9 pin D-SUB MALE connector and 9 pin D-SUB FEMALE connector

Source(s): Hardware Book
Document status: unknown
mark as erroneous!
mark as correct		 0 report(s)
Click one of this links to change document status.
[Discuss at the forum] [Back to index] [Add new pinout]
[Report an error or update]
This information is maintained by pinouts.ru team and provided as a guideline only.
Efforts have been made to ensure it is correct, but it is the responsibility of the user
to verify the data is correct for their application.
40 hits since February 12, 2005