Pinouts of Connectors

Cisco Auxiliary port for Cisco 1000, 1600, 2500, 2600, and 3600 series routers pinout

layout
schematic diagram
add this page to bookmarks

The auxiliary port is configured as data terminal equipment (DTE)

8 pin RJ45 FEMALE connector pin-out & layout
8 pin RJ45 FEMALE connector  at the cisco router
Pin Name Description Dir
1 RTS Request To Send OUT
2 DTR Data Terminal Ready OUT
3 TXD Tranceive Data OUT
4 GND Ground -
5 GND Ground -
6 RXD Receive Data IN
7 DSR Data Set Ready IN
8 CTS Clear To Send IN

This information should be correct, but may be not. You can help us to improve this webpage!
You can confirm this document to be correct (be careful), or report an error in document (error may be described in the following webpage). Result of your submission will be used for calculating document status shown at the bottom of this page.
8 pin RJ45 MALE connector pin-outs & layouts
8 pin RJ45 MALE connector  at the the cables
Pinouts.ru > Pinouts of serial ports >  Pinout of Cisco Auxiliary port for Cisco 1000, 1600, 2500, 2600, and 3600 series routers and layout of 8 pin RJ45 FEMALE connector and 8 pin RJ45 MALE connector

Document status: unknown
mark as erroneous!
mark as correct		 0 report(s)
Click one of this links to change document status.
[Discuss at the forum] [Back to index] [Add new pinout]
[Report an error or update]
This information is maintained by pinouts.ru team and provided as a guideline only.
Efforts have been made to ensure it is correct, but it is the responsibility of the user
to verify the data is correct for their application.
61 hits since February 12, 2005