Pinouts of Connectors

Cisco EIA/TIA-232 (RS-232) DTE cable pinout

layout
schematic diagram
add this page to bookmarks

60 pin Cisco DB connector pin-out & layout
60 pin Cisco DB connector
60 Pin1 Signal Description Direction 25 Pin Signal
J1-50
J1-51
J1-52		 MODE_0
GND
MODE_DCE		 Shorting group - - -
J1-46 Shield GND Single - J2-1 Shield GND
J1-41
Shield		 TxD/RxD
-		 Twisted pair no. 5 -->
-		 J2-2
Shield		 TxD
-
J1-36
Shield		 RxD/TxD
-		 Twisted pair no. 9 <--
-		 J2-3
Shield		 RxD
-
J1-42
Shield		 RTS/CTS
-		 Twisted pair no. 4 -->
-		 J2-4
Shield		 RTS
-
J1-35
Shield		 CTS/RTS
-		 Twisted pair no. 10 <--
-		 J2-5
Shield		 CTS
-
J1-34
Shield		 DSR/DTR
-		 Twisted pair no. 11 <--
-		 J2-6
Shield		 DSR
-
J1-45
Shield		 Circuit GND
-		 Twisted pair no. 1 -
-		 J2-7
Shield		 Circuit GND
-
J1-33
Shield		 DCD/LL
-		 Twisted pair no. 12 <--
-		 J2-8
Shield		 DCD
-
J1-37
Shield		 TxC/NIL
-		 Twisted pair no. 8 <--
-		 J2-15
Shield		 TxC
-
J1-38
Shield		 RxC/TxCE
-		 Twisted pair no. 7 <--
-		 J2-17
Shield		 RxC
-
J1-44
Shield		 LL/DCD
-		 Twisted pair no. 2 -->
-		 J2-18
Shield		 LTST
-
J1-43
Shield		 DTR/DSR
-		 Twisted pair no. 3 -->
-		 J2-20
Shield		 DTR
-
J1-39
Shield		 TxCE/TxC
-		 Twisted pair no. 6 -->
-		 J2-24
Shield		 TxCE
-

Arrows indicate signal direction: --> indicates DTE to DCE, and <-- indicates DCE to DTE.

1 Any pin not referenced is not connected.

This information should be correct, but may be not. You can help us to improve this webpage!
You can confirm this document to be correct (be careful), or report an error in document (error may be described in the following webpage). Result of your submission will be used for calculating document status shown at the bottom of this page.
25 pin Cisco DB connector pin-outs & layouts
25 pin Cisco DB connector
Pinouts.ru > Pinouts and schemes of serial ports cables >  Pinout of Cisco EIA/TIA-232 (RS-232) DTE cable and layout of 60 pin Cisco DB connector and 25 pin Cisco DB connector

Source(s): Cisco Systems, Inc. and Technick.net
Document status: unknown
mark as erroneous!
mark as correct		 0 report(s)
Click one of this links to change document status.
[Discuss at the forum] [Back to index] [Add new pinout]
[Report an error or update]
This information is maintained by pinouts.ru team and provided as a guideline only.
Efforts have been made to ensure it is correct, but it is the responsibility of the user
to verify the data is correct for their application.
55 hits since February 11, 2005