Pinouts of Connectors

Cisco X.21 DCE cable (DB-60 to DB-15) pinout

layout
schematic diagram
add this page to bookmarks

This document describes the X.21 cable assembly and pinouts (Data Communications - DCE).

60 pin Cisco DB connector pin-out & layout
60 pin Cisco DB connector
60 Pin1 Signal Description Direction 15 Pin Signal
J1-48
J1-47		 GND
MODE_2		 Shorting group - - -
J1-46 Shield_GND Single - J2-1 Shield GND
J1-28
J1-27		 RxD/TxD+
RxD/TxD-		 Twisted pair no. 6 -
-		 J2-2
J2-9		 Transmit+
Transmit-
J1-1
J1-2		 CTS/RTS+
CTS/RTS-		 Twisted pair no. 1 -
-		 J2-3
J2-10		 Control+
Control-
J1-11
J1-12		 TxD/RxD+
TxD/RxD-		 Twisted pair no. 3 -
-		 J2-4
J2-11		 Receive+
Receive-
J1-9
J1-10		 RTS/CTS+
RTS/CTS-		 Twisted pair no. 2 -
-		 J2-5
J2-12		 Indication+
Indication-
J1-24
J1-23		 TxC/RxC+
TxC/RxC-		 Twisted pair no. 4 -
-		 J2-6
J2-13		 Timing+
Timing-
J1-15
Shield		 Control_GND
-		 Twisted pair no. 5 -
-		 J2-8
Shield		 Control GND
-

Arrows indicate signal direction: - indicates DTE to DCE, and - indicates DCE to DTE.

1 Any pin not referenced is not connected.

This information should be correct, but may be not. You can help us to improve this webpage!
You can confirm this document to be correct (be careful), or report an error in document (error may be described in the following webpage). Result of your submission will be used for calculating document status shown at the bottom of this page.
15 pin Cisco DB connector pin-outs & layouts
15 pin Cisco DB connector
Pinouts.ru > Pinouts and schemes of serial ports cables >  Pinout of Cisco X.21 DCE cable (DB-60 to DB-15) and layout of 60 pin Cisco DB connector and 15 pin Cisco DB connector

Source(s): Cisco Systems, Inc. and Technick.net
Document status: unknown
mark as erroneous!
mark as correct		 0 report(s)
Click one of this links to change document status.
[Discuss at the forum] [Back to index] [Add new pinout]
[Report an error or update]
This information is maintained by pinouts.ru team and provided as a guideline only.
Efforts have been made to ensure it is correct, but it is the responsibility of the user
to verify the data is correct for their application.
49 hits since February 12, 2005