pinouts

ST506/412 connector

pinout (распиновка)

запомнить адрес в закладки

Developed by Seagate. Also known as MFM or RLL since these are the encoding methods used to store data. Seagate originally developed it to support their ST506 (5 MB) and ST412 (10 MB) drives.

разъем 34 pin IDC MALE
34 pin IDC MALE connector  at the controller

The first drives used an encoding method called MFM (Modified Frequency Modulation). Later a new encoding method was developed, RLL (Run Length Limited). RLL had the advantage that it was possible to store 50% more with it. But it required better drives. This is almost never an problem. Often called 2,7 RLL because the recording scheme involves patterns with no more than 7 successive zeros and no less than two.

Second connector: 20 PIN IDC MALE at the Controller.
20 PIN IDC MALE

20 PIN IDC FEMALE at the Harddisk.
20 PIN IDC FEMALE

Control connector

Pin Name Description
2 Head Sel 8
4 Head Sel 4
6 Write Gate
8 Seek Complete
10 Track 0
12 Write Fault
14 Head Sel 1
16 RES (reserved)
18 Head Sel 2
20 Index
22 Ready
24 Step
26 Drive Sel 1
28 Drive Sel 2
30 Drive Sel 3
32 Drive Sel 4
34 Direction In
Note: All odd pins are GND, Ground.

Data connector

Pin Name Description
1 Drive Selected
2 GND Ground
3 RES (reserved)
4 GND Ground
5 RES (reserved)
6 GND Ground
7 RES (reserved)
8 GND Ground
9 RES (reserved)
10 RES (reserved)
11 GND Ground
12 GND Ground
13 Write Data+
14 Write Data-
15 GND Ground
16 GND Ground
17 Read Data+
18 Read Data-
19 GND Ground
20 GND Ground

Эта информация должна быть правильной, но ошибки вполне возможны. Вы можете помочь!
Вы можете подтвердить правильность документа (только если действительно уверены), или сообщить об ошибке в документе (ошибка может быть описана далее по ссылке). Ваше мнение будет учтено при расчете статуса документа.
34 pin IDC FEMALE
34 pin IDC FEMALE connector  at the harddisk
Pinouts.ru > Разъемы для подключения винчестеров >  Распиновка ST506/412 connector использующего разъем 34 pin IDC MALE и разъем 34 pin IDC FEMALE

Источник(и): Hardware Book
Статус документа: не подтвержденный
отметить как ошибочный!
отметить как правильный
0 отзыв(ов)
Щелкните по одной из ссылок для изменения статуса документа.
[Обсудить на форуме] [Назад к оглавлению] [Добавить распайку]
[Сообщить об ошибке или обновлении]
Maintained by pinouts.ru team
This information is provided as a guideline only.
Efforts have been made to ensure it is correct, but it is the responsibility of the user
to verify the data is correct for their application
47 hits since February 12, 2005