Pinouts of Connectors

Apple Duo Dock Modem Adapter Card connector pinout

layout
schematic diagram
add this page to bookmarks

10 pin unknown connector

Pin Name Description
1 LINET/R Line/talk receive
2 DAA GND Modem DAA ground
3 DAA GND Modem DAA ground
4 DAA GND Modem DAA ground
5 /RA DVR Modem relay A driver
6 DAA ID IN ID input
7 /RING3 DET Ring detect signal
8 /RBDVR Modem relay B driver
9 DAA CNTL Modem DAA control
10 +5 V MODEM +5 V power

When the PowerBook Duo computer is housed in the Duo Dock, you cannot access the integral modem via the RJ-11 connector on the PowerBook Duo's rear panel. A modem adapter card provides the connection. It plugs into the side of the Duo Dock's main logic board, using a 10-pin header connector. The card supplies the RJ-11 hook up, which is accessed on the rear panel of the Duo Dock. The adapter card interfaces with the modem card in the PowerBook Duo computer via its 10-pin connector, printed circuit traces, and the 152-pin expansion connector.

This information should be correct, but may be not. You can help us to improve this webpage!
You can confirm this document to be correct (be careful), or report an error in document (error may be described in the following webpage). Result of your submission will be used for calculating document status shown at the bottom of this page.
Pinouts.ru > Pinouts of serial ports >  Pinout of Apple Duo Dock Modem Adapter Card connector and layout of connector

Source(s): Apple Tech Info Library 12929: Duo Dock/Duo Dock II, External Pinouts at Apple TIL homepage, from Hardware Book
Document status: unknown
mark as erroneous!
mark as correct		 0 report(s)
Click one of this links to change document status.
[Discuss at the forum] [Back to index] [Add new pinout]
[Report an error or update]
This information is maintained by pinouts.ru team and provided as a guideline only.
Efforts have been made to ensure it is correct, but it is the responsibility of the user
to verify the data is correct for their application.
48 hits since February 12, 2005