Pinouts of Connectors

DFP-compliant MDR-20 pinout

layout
schematic diagram

add this page to bookmarks

20 pin MDR20 FEMALE connector pin-out & layout
20 pin MDR20 FEMALE connector  at the videocard

The DFP connector is a 20 pin connector. It and the DVI connector carry the same type of digital signal (TMDS). The DFP connector was created before the DVI, by VESA, and is only designed to carry digital video, so there is no provision to carry analog.

Pin Signal
1 TMDS Data 1 +
2 TMDS Data 1 –
3 Ground
4 Ground
5 TMDS Data C +
6 TMDS Data C –
7 Ground
8 +5V
9 Reserved
10 Reserved
11 TMDS Data 2 +
12 TMDS Data 2 -
13 Ground
14 Ground
15 TMDS Data 0 +
16 TMDS Data 0 -
17 Reserved
18 Reserved
19 DDC Data
20 DDC Clock

Signal type: digital. DDC = Display Data Channel. T.M.D.S. = Transition Minimized Differential Signal.

This information should be correct, but may be not. You can help us to improve this webpage!
You can confirm this document to be correct (be careful), or report an error in document (error may be described in the following webpage). Result of your submission will be used for calculating document status shown at the bottom of this page.
Pinouts.ru > Pinouts of video connectors >  Pinout of DFP-compliant MDR-20 and layout of 20 pin MDR20 FEMALE connector

Source(s): Matrox G200 Flat Panel Add-On - User Guide
Document status: unknown
mark as erroneous!
mark as correct
0 report(s)
Click one of this links to change document status.
[Discuss at the forum] [Back to index] [Add new pinout]
[Report an error or update]
This information is maintained by pinouts.ru team and provided as a guideline only.
Efforts have been made to ensure it is correct, but it is the responsibility of the user
to verify the data is correct for their application.
138 hits since February 12, 2005