Pinouts of Connectors

Ericsson T10S, T18S, A1018S, 628, 688, 788 mobile phones connector pinout

layout
schematic diagram

add this page to bookmarks

full pinout

12 pin Ericsson mobile special connector pin-out & layout
12 pin Ericsson mobile special connector  at the cellular phone
Pin Description Comments
1 Audio Out  
2 Audio In  
3 Accessory Sense. GND to enable External Mic and Speaker (Analog)  
4 Audio Signal GND  
5 Portable handsfree In. Internal/external mic and ear (0=External - open=Internal)
6 Music Mute Out, High when phone is used.  
7 In Flash Memory Voltage and Service Voltage,
In 0V=normal,+5V=test, +12V=test+flash
Test. Switch phone off and provide +5V and switch back on. (set comms at 9600, n,8,1)
8 Logic Out, Status On. Sources over 100mA. +5V output
9 TX (Data Out) from Mobile Station. Debug messages appear here at 112KBaud when in debug mode. TTL
10 Digital Ground and DC return  
11 Rx (Data in) TTL
12 DC in for battery charging, DC out for accessory power + external power supply 7.2Volt - 600mA

This information should be correct, but may be not. You can help us to improve this webpage!
You can confirm this document to be correct (be careful), or report an error in document (error may be described in the following webpage). Result of your submission will be used for calculating document status shown at the bottom of this page.
Related Links:
Pinouts.ru > Pinouts of cellular phones connectors >  Pinout of Ericsson T10S, T18S, A1018S, 628, 688, 788 mobile phones connector and layout of 12 pin Ericsson mobile special connector

Document status: unknown
mark as erroneous!
mark as correct
0 report(s)
Click one of this links to change document status.
[Discuss at the forum] [Back to index] [Add new pinout]
[Report an error or update]
This information is maintained by pinouts.ru team and provided as a guideline only.
Efforts have been made to ensure it is correct, but it is the responsibility of the user
to verify the data is correct for their application.
196 hits since February 11, 2005