Pinouts of Connectors

Apple iPOD connector pinout

layout
schematic diagram

add this page to bookmarks

30 pin iPOD special connector pin-out & layout
30 pin iPOD special connector  at the player ( white side up)
Pin Signal Description
2GND Audio ground
3Right Audio right channel
4Left Audio Left channel
12Tx ipod sending line
13Rx ipod receiving line
11, 21Serial enable short pin 11 to GND (pin 30) and connect pin 21 by 500 KOhm resistor to GND in order to enable serial communications
19,20+12V Charging input
29,30GND  
The remote control is using 19200 baud 8N+1 (one startbit 8 data bits 1 Stopbit) with a delay of 12 microseconds between end of the stopbit and the beginning of the next startbit. But it is also working without this delay.
Electrical: high +3,3V low 0V
default line state: high

This information should be correct, but may be not. You can help us to improve this webpage!
You can confirm this document to be correct (be careful), or report an error in document (error may be described in the following webpage). Result of your submission will be used for calculating document status shown at the bottom of this page.
Pinouts.ru > PDA, HandHeld computers connectors >  Pinout of Apple iPOD connector and layout of 30 pin iPOD special connector

Document status: unknown
mark as erroneous!
mark as correct
0 report(s)
Click one of this links to change document status.
[Discuss at the forum] [Back to index] [Add new pinout]
[Report an error or update]
This information is maintained by pinouts.ru team and provided as a guideline only.
Efforts have been made to ensure it is correct, but it is the responsibility of the user
to verify the data is correct for their application.
255 hits since February 12, 2005