Pinouts of Connectors

Apple Macintosh External Floppy disk drive connector pinout

layout
schematic diagram

add this page to bookmarks

This connector is present on the Macintosh Duo MiniDock and PowerBook Duo Floppy adapter. An HDI-20 1.4 MB drive can be connected to this port.

20 pin Apple HDI-20 connector pin-out & layout
20 pin Apple HDI-20 connector  at the Apple computer, looking into cable-side connector
Pin Name Description
1 GND Signal Ground
2 GND Signal Ground
3 GND Signal Ground
4 GND Signal Ground
5 NC No connection
6 +5V +5 volts DC
7 +5V +5 volts DC
8 +5V +5 volts DC
9 +5V +5 volts DC
10 NC No connection
11 PH0 Phase 0: state control line
12 PH1 Phase 1: state control line
13 PH2 Phase 2: state control line
14 PH3 Phase 3: register write strobe
15 WREQ Write request
16 HDSEL Head select
17 ENBL2 External drive select
18 RD Read data
19 WR Write data
20 NC No connection

This information should be correct, but may be not. You can help us to improve this webpage!
You can confirm this document to be correct (be careful), or report an error in document (error may be described in the following webpage). Result of your submission will be used for calculating document status shown at the bottom of this page.
Pinouts.ru > Pinouts of different diskdrives connectors >  Pinout of Apple Macintosh External Floppy disk drive connector and layout of 20 pin Apple HDI-20 connector

Source(s): Apple "Ports and Pinouts", from Hardware Book
Document status: unknown
mark as erroneous!
mark as correct
0 report(s)
Click one of this links to change document status.
[Discuss at the forum] [Back to index] [Add new pinout]
[Report an error or update]
This information is maintained by pinouts.ru team and provided as a guideline only.
Efforts have been made to ensure it is correct, but it is the responsibility of the user
to verify the data is correct for their application.
56 hits since February 12, 2005